• Rejected by server

Message was rejected by remote SMTP server due to their antispam settings.

Most of large smtp servers do not accept mail from home computers (with dial-up or cable IP addresses). You need send mail via external SMTP server, it's highly recommended. Please open Settings / Common Settings / SMTP and add SMTP server of your Internet Service Provider (ISP) or hosting service.

• Transaction failed
• No such address
• User not local

It usually happens if you try send mail via the external SMTP server, but do not provide correct username / password when it's required. Please open Settings / Common Settings / SMTP, double click at the server name and change Authentication type. The most popular type is ESMTP. CRAM and DIGEST are used at the less number of servers, POP before SMTP is too old, not recommended to use.

Note for hotmail.com - please check HELO value. It's very important for them. Open Settings / Common Settings / Mailer and check value of HELO there. It must be the same as at www.massmailsoftware.com/ip.

• Remote server not answer
• Connection refused
• Can not access Internet
• DNS Server not responding

Atomic Mail Sender can not access the Internet or your Internet Service Provider (ISP) does not allow direct email delivery.

1. Please check your firewall and antivirus settings. These programs may block other applications to access network (ZoneAlarm, Panda, AVP, McAfee, Norton, Symantec Internet Security).

2. Make sure your ISP allows direct email delivery. If not, you need send all mail via ISP STMP server. Please open Settings / Common Settings / SMTP and add SMTP server of your ISP there (you can find list of SMTP servers of popular providers here).

3. If DNS problem, try use Custom DNS (change it in Common Settings / DNS). Try enter public worldwide DNS server - 204.101.251.2

• SMTP syntax error

• Authentication failure
• Error in SMTP AUTH

You have an error in username or password used to access external SMTP server.

Please open Settings / Common Settings / SMTP, then double click at the server name in the list and correct username and password there.

Note 1: Make sure CAPS LOCK is not pressed - it's important!

Note 2: Some smtp servers require username "user@mail.com" instead of "user", please investigate.

• Mailbox is full

It's temporary e-mail delivery failure.

Usually happens if too many connection from you to the smtp servers. Please decrease Threads Count in Common Settings, or Speed Limit.

If you see Delivering... for a long time (say more then a minute), you need check the following:

1. Your message is really large and Atomic Mail Sender need much time to deliver it.

2. Atomic Mail Sender is completely blocked by your antivirus or firewall and can not access Internet. Please check the settings of these programs.